|
|
Organ front
|
This tab shows the front of the organ and if you click on the picture you will see the church.
The Church inside
|
|
2. Console (simple stop representation)
|
Virtual Console
|
On this tab a simple representation of the stops of this organ.
The buttons with a bleu dot are added voor Hauptwerk using samples of this organ.
The button "Motor" turns the wind engine on.
The button "Tremulant Nevenwerk": This organ does not have a tremulant on the real organ, but for the enthusiast we have made one that you can switch on with this button.
This is a modulating tremulant and you can adjust this to your taste via the voicing.
With the 4 sliders at the top right, the volume of the different channels can be set, which allows you to broadly determine your listening position.
A good starting point is Front-Middle-Rear-Wall e.g. 31-46-69-100
The button "Trompet 8'" (Hoofdwerk): This button is split vertically. If you press the left part you will hear the bass side and if you press the right part you will hear the treble.
On the tab "3:Schakelaars" you find a button "Trompet 8 Vt gekoppeld". If this is "On", the Trumpet 8' is not split.
The pedalstops Prestant 8' and Gedekt 8' are not original and are so-called transpositions of the manual voices (so do not contain extra samples).
The couplers are all 3 original.
|
|
3. Schakelaars: (Switches)
|
Switches
|
Most elements of this tab do not actually need to be visible, but for interested parties it still gives a
a bit of an impression of what needs to be done to get a sample set of this size to work.
Keep in mind that behind each (manual) button there are 56 long, 56 long release, 56 medium release and 56 short release samples.
The same applies to the pedal, but always 30 pieces.
It is also useful to know that if you right-click on a switch you can immediately access the correct voicing screen.
In the column "Speelhulpen" (Playing aids) you will find 3 buttons:
With the button "Trekkergeluid" (Tracker noise) you can choose whether or not to hear the sounds of the trackers.
With the button "Manuaal Kopp. B/D" you can link bass and treble of the manual coupler.
With the button "Trumpet 8 Vt gekoppeld" you can choose whether the Trumpet 8' is split or not.
|
The windmodel
|
On these tabs a schematic representation of the wind supply of this organ.
With the various sliders you can control the supply of wind for the bellows and the various wind chests.
With the "R" or reset buttons you can return to the settings that we think are the most suitable (default values).
With the button "Sygsoft" at the bottom right you can reset all 7 sliders in one time.
Important:
If you decide not to load a part of this sample set (e.g. your computer RAM memory is too small and you choose e.g. to
omitting all "Wall" samples) then the wind consumption decreases by 25% and then the organ becomes much less wind sensitive than
it actually is.
In that case, go to Organ settings/Organ preferences/Wind supply model and choose a value of approx. 125.
In case you only need to load one channel e.g. "Middle", (the wind consumption decreases by 75%) then you need this value to about 400% to get the same result.
Obviously, you can choose any value if you don't like the organ's behavior.
With the check mark on this same Wind supply model tab you can turn off the wind supply completely.
|
|
|
Hauptwerk.nl is an initiative from Sygsoft Holland. KvK 93602855. Last updated
2024-04-20
|
|
|
